Dakota Digital MCL-3204 Automobile Parts User Manual

User manual for the device Dakota Digital MCL-3204 Automobile Parts

Dakota Digital MCL-3204 Automobile Parts User Manual

Extracts of contents

Content summary on the page No. 1

MODEL MCL-32043-3/8” SPEEDOMETER/TACHOMETER for 2004 – upIMPORTANT NOTE! This gauge has an odometer preset option that is only available one time in the first 100 miles(160km) of operation. See “Odometer preset” for instructions.GAUGE SETUP AND CALIBRATIONThe setup menus are entered by holding the switch in while turning the keyon. The menus are as follows:34120read diagnostic codesadjust calibrate speedselect speed unit (MPH or km/h)miles to service settingtransmission gear display sele

Content summary on the page No. 2

MOUNTINGThe gauge will mount using the original housing, grommet, and screws. Unbolt the two screws from the backplate at the back of the gauge housing, then unplug the factory gauge, noting the position of the grommets. There is onegrommet on the front between the gauge and housing and one on the back between the housing and the back plate.Install the Dakota Digital gauge in reverse order installing grommets and then plugging into the factory plug and securingwith the two screws.SPEEDOMETER SET

Content summary on the page No. 3

nIgHt Night DimmingYour display system has a dimming feature that dims the display intensity automatically at night. Normally the system is at fullbrightness for daytime viewing. To have the system at full brightness all of the time, go into the setup menu as described above andselect “ngt” (night). Press and release the function switch to select “OFF” instead of “on”. Press and hold the function switch to savethe new setting.•Press and release the switch until “nIgHt” is displ

Content summary on the page No. 4

PERF Performance menu setup••••The performance readings can be turned on or off. When they are turned off the odometer display will only toggle through themileage readings.Press and release the switch until “PErF” is displayed, then press and hold the switch until “ - ” is displayed.Release the switch. The current setting will be displayed (on or oFF).Press and release the switch until the desired setting is displayed.Press and hold the switch until “ - ” is displayed to save

Content summary on the page No. 5

Troubleshooting guideProblemGauge will not light up.Possible causeOrange/White wire does not have power.Brown/Gray wire does not have power.Black wire is not getting a good ground.Gauge is damaged.Clock resets when key is off. Brown/Gray wire does not have constant power.Gauge lights up, but speed No data from ECM.will only show zero.Sensor is not sending a speed signal.Speed reading is incorrect.Gauge is not calibrated correctly.Gauge lights up, but tachNo data from ECM.will only show zero.Gaug

LEAVE A COMMENT